How To Clean Toilet Bowl Choke?

How To Clean Toilet Bowl Choke? There’s nothing more frustrating than having your toilet stop up and overflow onto the floor due to clogging. After flushing, small amounts of water will remain in your toilet bowl. These leftover drops can create an air block that prevents all of your water from draining.

This situation is called a toilet bowl choke. If this happens to you, take comfort in knowing that you aren’t alone, and there are things you can do to clear the blockage and get your toilet working again in no time.

If you are a DIY enthusiast, all you need might be some knowledge on some available household solutions and you can handle the job on your own. In this article, we have discussed DIY tips on how to clean toilet bowl choke. So let’s get started!

Baking Soda and Vinegar

The combination of vinegar and baking soda is a common way to eliminate clogs in the toilet bowl. You just need to add 1 cup of baking soda to the toilet and leave it to sit for about one minute.

After that, put in 2 cups of vinegar, carefully and slowly. You don’t want to let the frothy, unpleasant reaction of these 2 products splash all over your toilet floor. After allowing the mixture to settle for a while, flush the toilet to see whether the clog has cleared.

Pour some hot water

It might sound simple but hot water with dish soap can astonishingly get rid of your toilet clog. Just heat about one gallon of water on the stove, but do not let the water reach the boiling point. As you wait for the water to boil, pour a little soap into the toilet bowl. Pour the hot water into the toilet while ensuring that there is no risk of overflow.

After that, wait for a few minutes to allow the clog to be softened. You will know whether your effort was successful if you find that the water starts to drain. Give your toilet a flush. Hot water is enough to soften and break up what is causing the backup.

Use a bent wire hanger

Take your standard wire hanger and then force to have it straightened and make a small hook at end of the wire. Push the hook down the toilet bowl drain and try to the lug that is causing the toilet bowl to choke or block. Get out whatever that is causing the toilet to stuck.

This will assist to remove the choke that is inside such as hair, cloth-based materials, waste materials, or cotton-based materials. When inserting the wire, ensure that you do not push the stuff further inside the toilet bowl. Instead, pull them out if it is possible.

After you have taken out most of the stuff from the drain, you can then pour some hot water to clear up all the remaining residuals.

Use a Plunger

This is one of the classic methods if you want to get rid of toilet clogs. You can get this device from the stores. The plunger has a flange or a rubber flap on the end.

This flange will create a perfect seal with toilet drain and with a push, it will get rid of the clog. Repeat the same process severally while ensuring that you keep a tight seal. You will see the water rushing down the drain when the clog has been released.

Use dish detergent

Dish detergents can be used to remove your blocked toilet bowl worries. What you just need to do is to pour ¼ cup of dish detergent into the toilet bowl. What will happen is that the detergent will degrade and lubricate any residue of fatty or greasy materials. After that, pour some boiling water and then begin plunging.

Use a Plastic Bottle to Create Water Pressure

Warning: This trick could get messy.

First, remove as much water from your toilet bowl as possible. This can be done by repetitively filling a small container with the toilet water and then pouring it onto the bucket. After that, take a large plastic bottle and fill it with warm water.

Wear rubber gloves and then place your thumb on the top of the bottle filled with water. Fit the end of the bottle into the bottom of the toilet outlet. Remove your thumb and then squeeze the bottle by applying pressure so that the water inside shoots down the drainage pipe. The added pressure will remove the clogging that is making the toilet block.

Brush Battle

If you do not have a plunger insight, then you can use a toilet brush to clean the toilet bowl. Although this may seem a little unpleasant.

All you have to do is to grab a toilet brush and then angle the brush bristles down the drain. Pump it down and up several times to ensure that you loosen up things that are clogging the toilet. You must be careful to ensure that you do not block the toilet further.

Bathroom Bomb

You can create your DIY de-clogger by mixing 1/4 cup Epsom salt, 2 cups baking soda, and 8-10 tablespoons of dish detergent. After that, pour the mixture into individual muffin liners. Let it dry and harden for a whole day. Drop one into your toilet bowl and then add 4 cups of water. Wait for a few hours to see the results.

Use a drain snake

This is an inexpensive plumbing tool that you can use to give an awesome result to sort out a clogged toilet drain. The equipment has a metal spiral ending and a long metal rope which is very flexible. You can insert it in the toilet drain and rotate it back and forth to remove the materials that are causing it to block.

How To Clean Toilet Bowl Choke? – Conclusion

These are some tips on how to clean a toilet bowl choke. Make sure that you’re aware of all possible hazards before trying to clear a toilet to choke on your own. If the problem persists, it is recommended to hire professional plumbing services to clean the toilet for you.